Table of Contents
Advertisement
FIRMWARE UPDATE PROCEDURE
Updating the lpr Command
Preparation on the printer
1. Turn the main switch on.
2. Wait until
Ready
3. Print out Configuration Page in case you need to refer to the current settings.
4. Connect the printer and the PC with the Ethernet cross cable.
5. Select the menu
6. Select the submenu
Yes."
7. Select the submenu
133.139.157.101)
8. Select the submenu
255.255.255.0)
9. Select the submenu
(e.g. 133.139.157.001)
10. Select the submenu
to
No."
11. Press the Cancel key. The system reboots automatically.
12. Open the front cover.
Preparation on the PC
1. Set the TCP/IP address for your PC. (e.g. 133.139.157.010)
NOTE: Do not use the IP address of the printer.
2. Set the Subnet Mask (e.g. 255.255.255.0).
3. Reboot the PC.
Upgrade Procedure
1. Check that the printer front cover is open.
2. Use Run in the Windows Start Menu.
3. Transfer the firmware to the printer by using the lpr command.
(e.g. lpr -S 133.139.157.101 -P xjdirect "Firmware File Name")
NOTE: In the example,
firmware.
is displayed.
Network Protocol Setup."
TCP/IP-Ethernet,
Eth. IP Address,
Eth. Subnet Mask," and input the address mask. (e.g.
Gateway Address,
Enable AppleTalk,
Firmware File Name" indicates the file name of the
5-8
Ready
and change the setting from
and input the IP address. (e.g.
and input the gateway address.
and change the setting from
26 April, 2002
G082S910.WMF
No
to
Yes
Advertisement
Table of Contents
