Table of Contents
Advertisement
FIRMWARE UPDATE PROCEDURE
5.4.4 FIRMWARE UPGRADE
!
CAUTION
1. Open the front cover whenever updating the firmware.
2. Do not turn off the machine while downloading the firmware.
Upgrading Printer Firmware
To upgrade the firmware, you must connect the printer to your PC with the Ethernet
cross cable. There are two ways:
1) Using Fiery WebTool:
2) Using the lpr command: Sends the files by using the command line
NOTE: In this section, Web browser
or
Netscape 4.5 or later."
Using Fiery WebTools
Preparation on the printer
1. Turn the main switch on.
2. Wait until
Ready
3. Print out the Configuration Page.
4. Connect the printer and PC with the Ethernet cross cable.
5. Select the menu
6. Select the submenu
Yes."
7. Select the submenu "Eth. IP Address," and input the IP address. (e.g.
133.139.157.101)
8. Select the submenu "Eth. Subnet Mask," and input the address mask. (e.g.
255.255.255.0)
9. Select the submenu
(e.g. 133.139.157.001)
10. Select the submenu
to
No."
11. Press the Cancel key. The system reboots automatically.
12. Open the front cover.
Sends the files by using a Web browser
is displayed.
Network Protocol Setup."
TCP/IP-Ethernet,
Gateway Address,
Enable AppleTalk,
5-6
indicates
Internet Explorer 5.0 or later,
Ready
and change the setting from
and input the gateway address.
and change the setting from
26 April, 2002
G082S910.WMF
No
to
Yes
Advertisement
Table of Contents
