Configuration; To Set A Different Address - Daikin FTXTP25M5V1B Installer's Reference Manual

11 |

Configuration

11 Configuration

11.1 To set a different address

Installer reference guide
46
In case 2 indoor units are installed in 1 room, different addresses for 2 user
interfaces can be set.
1 Remove the batteries from the user interface.
2 Cut the address jumper.
a Address jumper
NOTICE
Be careful NOT to damage any of the surrounding parts when cutting the address
jumper.
3 Turn the power supply on.
Result: The flap of the indoor unit will open and close to set the reference position.
4 Press simultaneously
5 Press and select .
6 Press to confirm selection.
a Operation lamp
b Indoor unit ON/OFF switch
7 Press the indoor unit ON/OFF switch while the operation lamp is blinking.
Jumper
Factory set default
After cutting jumper
INFORMATION
If the setting could NOT be completed while the operation lamp was blinking, repeat
the setting process from the beginning.
a
, and .
a
b
ON/OFF
Address
1
2
a
FTXTP25+35M5V1B_ATXTP25+35M5V1B
Daikin room air conditioner
4P519439-13N – 2021.03