Transport And Storage - Trotec TTK 99 HEPA Operating Manual

Device depiction
6
No. Designation
1 Control panel
2 Colour LED display for room humidity
3 Transport handle
1
2
4 Air outlet
5 Condensation tank
6 Air inlet
3
7 Condensation drain hose connection
4
8 Power cable holder
9 Air filter
10 HEPA filter
5
11 Condensation drain hose

Transport and storage

Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Please note that additional transport regulations might apply to
6
devices containing flammable refrigerants. The equipment's
arrangement and the maximum number of components to be
7
transported together can be gathered from the applicable
transport regulations.
To make the device easier to transport, it is fitted with a carry
handle.
8
Before transporting the device, observe the following:
• Switch the device off.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
• Do not use the power cable to drag the device.
9
After transporting the device, proceed as follows:
• Set up the device in an upright position after transport.
• Leave the device to rest for 12 to 24 hours, so the
refrigerant can accumulate within the compressor. Wait
12 to 24 hours before switching the device back on! Acting
contrary might lead to compressor damage and a
10
malfunctioning device. If so, any warranty claims will be
voided.
11
dehumidifier TTK 99 HEPA EN