Transport And Handling; Transport - York JVOHQ Series Installation & Maintenance Manual

NOTE:
In a system, where all the indoor units are running, the capacity of the total indoor units should be less than or equal to the
combined capacity of the outdoor unit. Otherwise, the overloading operation may occur in the case of harsh working conditions or
in narrow operation range.
For systems where all the indoor units are not running at the same time, the total capacity of the indoor units can be allowed to
up to 130% of the total capacity of the outdoor unit.
If the system is used in cold areas (where ambient temperature below -10°C) or high heat load environment, total capacity of the
indoor units should be less than the total capacity of outdoor unit, and the total pipe length should be less than 300m.
Indoor unit of model with the type of capacity range of 18~36 have much more air flow per unit cooling capacity than 40 and
above models of the unit. If the system uses more indoor units with model of 18~36, user can feel of cold wind blow. At this time,
the recommended number of connectable indoor units is a benchmark.
For air conditioner with outdoor fresh air handling, the number of indoor units must be within the recommended number of
connectable indoor units.
If the indoor unit capacity exceeds 100%, but less than 130%, please refer to the Technical Bulletin for details.
If the temperature in the installation place of the outdoor unit sustainably exceeds 48°C ,the total connection capacity of the
indoor units should be less than the total capacity of the outdoor units.

4. Transport and Handling

4.1 Transport

Transport the machine to a place as close as possible to the installation site before unpacking the
machine.
When handling with a hoist, follow the lifting instructions on the machine package.
When hanging, do not route the rope through the wooden base.
● Transport and storage
Strength of machine packaging cardboard is limited, so please note the following:
* It is forbidden to tread on the machine packaging, it is strictly prohibited placing any
material on the appliance.
* When lifting with a crane, please use 2 slings for transporting and storing.
* Do not store machines which are stacked up.
● Transport and packing
* To protect the unit, do not remove any packaging.
* It is forbidden to stack up or place any material on the machine.
* Machine is bundled at both sides as shown below:
DANGER
!
Sling Position
NOTICE
9