15
|
Operation
15.1.4 To operate the system
15.2 Using the dry program
15.2.1 About the dry program
15.2.2 To use the dry program
15.3 Adjusting the air flow direction
15.3.1 About the air flow flap
Installer and user reference guide
58
1 Press the operation mode selector button on the user interface several times
and select the operation mode of your choice.
Cooling operation
Heating operation
Fan only operation
2 Press the ON/OFF button on the user interface.
Result: The operation lamp lights up and the system starts operating.
▪
The function of this program is to decrease the humidity in your room with
minimal temperature decrease (minimal room cooling).
▪
The micro computer automatically determines temperature and fan speed
(cannot be set by the user interface).
▪
The system does not go into operation if the room temperature is low (<20°C).
To start
1 Press the ON/OFF button of the user interface.
Result: The operation lamp lights up and the system starts operating.
To stop
2 Press the ON/OFF button on the user interface once again.
Result: The operation lamp goes out and the system stops operating.
NOTICE
Do not turn off power immediately after the unit stops, but wait for at least 5
minutes.
Refer to the operation manual of the user interface.
For the following conditions, a micro computer controls the air flow direction
which may be different from the display.
Double flow+multi-flow units
FXFQ20~125BVEB
VRV system air conditioner
4P561452-1B – 2021.07