Porsche 911 Installation And Conversion Instructions page 7

Installation and Conversion Instructions
2.2
Adhesive films not prepared/installed correctly
• Damage to adhesive films
• Inadequate adhesion of adhesive films
 Carefully clean the areas on which you intend to stick the film to ensure that all traces
of oil, grease and silicone are completely removed.
 Do not touch the bonding surfaces.
 Object (adhesive film, vehicle, etc.) and ambient temperature: Minimum temperature
15°C / 59°F.
Dimension Z = distance from inner edge of outline of front camera base to inner
edge of outline of interior mirror: Length 55 mm +/-3 mm
Information
Observe the following points during positioning/alignment:
• Sufficient distance between front camera and interior mirror base: at least 5
mm/ 0.2 in!
• Get another person standing in front of the vehicle to check and confirm the
horizontal alignment of the camera with the PORSCHE logo!
2.1.4 Position front camera with retainer plate in the vehicle at the marking on the wind-
shield.
2.1.5 Get another person to trace and shade in the outline of the retainer plate on the
outside of the windshield using a marking pencil/chalk.
2.1.6 Clean the inside of the windshield in the bonding area for the retainer plate (shaded
area) to remove any dust and grease.
Install front camera (dashcam) on the windshield
NOTICE
Tequipment
911 (992)
06 / 21
9163
ENU
Jul 7, 2021
Page 7 of 21
9