Porsche 911 Speaker Operating Manual
Hide thumbs Also See for 911 Speaker:

Advertisement

Porsche
911 Speaker.
EN
Betriebsanleitung_911_Speaker_420x148mm_EN.indd 32-1
15.08.17 09:13

Advertisement

Table of Contents
loading

Summary of Contents for Porsche 911 Speaker

  • Page 1 Porsche 911 Speaker. Betriebsanleitung_911_Speaker_420x148mm_EN.indd 32-1 15.08.17 09:13...
  • Page 2: Table Of Contents

    Porsche 911 GT3. The new 911 Speaker takes the fascination of Porsche and turns it into a breathtaking designer piece equipped with cutting-edge technology – a real treat for the senses – with True Wireless mode and a battery life of up to 24h.
  • Page 3: Important Safety Instructions

    Do not allow liquid to drop or spray onto the device. Place the device in an horizontal position, standing it on the rubber-coated area so that the Porsche logo is on the top. Strong temperature fluctuations can lead to condensation [ water droplets ] inside the device. Wait until the moisture Do not place the device close to any edges [ table or shelf edges ] to prevent any knocks and shakes from causing it to fall down.
  • Page 4 [ EN ] The 911 Speaker Important safety instructions Do not subject the operating elements, connections and cables to violence. The device may only be operated in ambient temperatures of between 0 and 45 °C. The device may only be operated at the voltage and frequency specified on the plug-in power supply or the rating plate.
  • Page 5: Unpacking

    [ EN ] The 911 Speaker Unpacking Connections DC IN Service AUX-IN Ensure that the 911 Speaker and the plug-in power supply including adapter are all in the box. If the box does not contain all the aforementioned parts, 1. DC IN [ For plug-in power supply ] please contact your authorised dealer directly.
  • Page 6: Connection

    [ maximum reach 10 m ]. 5. Look for nearby Bluetooth ® 4. Place your source device with the NFC antenna on the NFC sensor of the 911 Speaker until a connection request is displayed. 6. Select ‘911 Speaker’. 5. Remove your Bluetooth device and confirm the connection request.
  • Page 7: Aux Connection

    [ EN ] The 911 Speaker AUX connection AUX connection If your source device is equipped with a LINE-OUT or headphone output, it can also be connected with the 911 Speaker via the AUX-IN 1. 911 Speaker port using an optionally available 3.5-mm audio jack cable. The procedure is as follows: 2.
  • Page 8: True Wireless

    [ the LED flashes or illuminates in blue ] for 911 Speaker 1. 2. Select the Bluetooth ® input 3. Simultaneously press on 911 Speaker 1’s Bluetooth and volume buttons for a short time; you will hear the message ® ‘True Wireless pairing’.
  • Page 9 [ EN ] The 911 Speaker Party mode Please note: The devices will automatically save the last True Wireless status; this status can only be deleted by simultaneously pressing the To swap from stereo mode to party mode, press the Bluetooth button on 911 Speaker 1 multiple times for around three seconds, until you hear...
  • Page 10: Charging Function

    During the charging process, the LED in the power button will display the battery charging status.[ see battery status ]. When the LED light in the power button is blue, the battery of your 911 Speaker is fully charged.
  • Page 11: Voice Messages

    Bluetooth ® flashing white light Registration process ‘Bluetooth pairing’ Bluetooth registration process ® ® Bluetooth flashing white light Two devices connected to the 911 Speaker simultaneously ® ‘Connected’ Bluetooth ® connection established | AUX Bluetooth ® Standby ‘Disconnected’ Bluetooth connection removed ®...
  • Page 12: Troubleshooting

    911 Speaker and the source device. Please note: The 911 Speaker service hotline is operated by an authorised partner of the Porsche Design Group. Sound distorted. 1. The volume is too high. 1. Reduce the volume.
  • Page 13 911 Speaker or source device. 3. Two source devices are connected with one of the 3. Remove the connection with at least one of the two source 3.2. It is often not possible to connect the 911 Speaker with a 911 Speakers. devices.
  • Page 14 The AUX input cannot be This 911 Speaker is connected via True Wireless with Only select the AUX input on the 911 Speaker you want to connect switching off the first and switching off the second switching off the second 911 Speaker.
  • Page 15: Technical Data

    Passive radiator 2× [ 70 × 50 mm ] metal, wave surround [ passive ] the 911 Speaker. This prevents the plug-in power supply from constantly of with the municipal waste [ household waste ]. To find out supplying power, thus reducing costs.
  • Page 16: License-Related Information

    ® trademarks owned by Bluetooth ® SIG, Inc., and any use of such marks by Porsche Design is under license. Other trademarks and trade names are those of their respective owners. aptX ® The aptX software is a copyright of CSR plc or its group ®...

Table of Contents