Porsche 911 Installation And Conversion Instructions page 10

9
911 (992)
06/21
9163
ENU
Jul 7, 2021
Page 10 of 21
Installation and Conversion Instructions
3.1.3 Guide wire harness for front camera (dashcam) vertically with respect to the
headliner/roof console.
3.1.4 Push protective foam roll over the
(3-pin) plug connection.
1 – Wire harness for front
camera (dashcam)
2 – Tie-wrap
3 – Protective foam roll
Secure (3-pin) plug connection
and connection for front camera
wiring harness to existing
components/lines under the
headliner in the roof console area
 Figure 13 -2-.
with tie-wraps
Protective foam roll must also be wrapped around the connection
 Figure 12 -4- must be installed behind the connection.
3.1.5 Route the rest of the wire harness
 Figure 14 -1-to the left fuse box
 Figure 14 -2- as follows, shorten
the wiring harness as required and
then attach the contacts.
1 – Wire harness for front
camera (dashcam)
2 – Fuse carrier on dashboard
(left)
• Roof console → under
headliner along windshield
frame → right A-pillar (top) →
along A-pillar → over center
tunnel → fuse carrier on
dashboard (left
-2-) → BK 0.5² line → ground
pin
Tequipment

Figure 14
Figure 13
 Figure 12 -4-.
Figure 14