Porsche 911 Installation And Conversion Instructions page 12

9
911 (992)
06/21
9163
ENU
3.3
4 Concluding work
4.1
4.2
4.3
4.4
4.5
4.6
4.7
4.8
Jul 7, 2021
Page 12 of 21
Installation and Conversion Instructions
3.2.5 Route line  Figure 16 -1- BK; 0.5²
(terminal 31) to the ground pin and
install to the ground pin using cable
ring eyelet (  Figure 16 -2-).
3.2.6 Install fuse holder.
Manual 'Loosening and securing
fuse box in front left footwell'
Secure routed wire harness to existing
lines/components in the vehicle with
tie-wraps without tensile stress and so that no
chafing occurs.
Secure extra length of line if necessary.
File down mirror cover using a round file.

Manufacture a cable guide
area around the line output -1-.
Install cover for interior mirror.
Manual 'Removing and installing interior
rear-view mirror'
Install sun visors.  Workshop Manual
'Removing and installing sun visor'

Install A-pillar (right). Workshop Manual
'Removing and installing A-pillar trim panel
(upper part)'
Install fuse box cover (left and right).
side-section trim panel'
Install lower dashboard cover.
panel'
Install dashboard trim panel (left and right).
dashboard trim panel'
Clean inside and outside of the windshield.
Tequipment
 Workshop
File down the

Workshop
File down the area around the line output

Workshop Manual 'Removing and installing front

Workshop Manual 'Removing and installing dashboard trim
 Workshop Manual 'Removing and installing
Figure 16