Troubleshooting - Beem S3.8.4 Manual

31
For descaling we recommend the BEEM Premium Descaler Concentrate. The effi cient and food-safe
BEEM Premium Descaler Concentrate is available from selected specialist stockists, via our website
www.beem.de or from our customer service department on request.
Descaling with the BEEM Premium Descaler Concentrate
1. Fill the water reservoir (5) up to the MAX marking with a concentrate/water solution of no
more than 1:20 (one part concentrate to 20 parts water).
2. Turn the control dial (6) to the highest temperature (
ing control lamp
3. As soon as the solution has boiled, turn the control dial down to a lower temperature. Let the
solution take effect for a little while.
4. Allow the solution to run through the discharge tap (12) so that it is also freed of any limes-
cale residues (see the "Operation" chapter – "Operating the Discharge Tap").
5. To rinse the device, allow two tankfuls of clear water to run through it. The device is now
descaled and ready to be used again.
Storage
Disconnect the device from the mains power when it is not going to be used for a prolonged
period. Clean the device again (see the "Cleaning and Care" chapter) to avoid possible mould
formation. Mould can cause spots and damage on the device that can no longer be removed /
repaired. Allow the device and all accessories to dry completely.
Store the device and all accessories in a dry, clean, frost-free place that is protected from direct
sunlight and cannot be accessed by children or animals.

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem yourself.
If the problem cannot be solved with the steps listed, contact the customer service department.
Do not attempt to repair an electrical device yourself!
Problem
The device cannot be
switched on.
The fuse in the fuse
box is triggered.
07204_DE-EN-FR-ES-IT_A5_V3.indb 31 07204_DE-EN-FR-ES-IT_A5_V3.indb 31
(11) lights up. The solution starts boiling.
Possible cause
The mains plug is not inserted
correctly in the plug socket.
The plug socket is defective.
There is no mains voltage.
The control dial (6) has not been
activated.
Too many devices connected to
the same circuit.
) to switch on the device. The heat-
Fix
Insert the mains plug.
Try another plug socket.
Check the fuse of the mains
connection.
Turn the control dial to the
highest temperature (
Reduce the number of devices in
the circuit.
EN
).
08.02.2021 11:43:29 08.02.2021 11:43:29