Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Motorline professional CHAINLIFT
Summary of Contents for Motorline professional CHAINLIFT
- Page 1 CHAINLIFT CHAINLIFT USER/INSTALLER MANUAL v1.0 REV. 02/2021...
-
Page 2: Table Of Contents
00. CONTENT 01. SAFETY INSTRUCTIONS INDEX STANDARDS TO FOLLOW 01. SAFETY INSTRUCTIONS This product is certified in accordance with European STANDARDS TO FOLLOW Community (EC) safety standards. 02. OPERATOR This product complies with Directive 2011/65/EU of the TECHNICAL SPECIFICATIONS European Parliament and of the Council, of 8 June 2011, on DIMENSIONS the restriction of the use of certain hazardous substances in INSIDE THE PACKAGE... -
Page 3: Safety Instructions
01. SAFETY INSTRUCTIONS GENERAL WARNINGS the risks and dangers involved. • Children shouldn’t play with the product or opening devices to avoid • This manual contains very important safety and usage information. the motorized door or gate from being triggered involuntarily. very important. - Page 4 01. SAFETY INSTRUCTIONS RESPONSABILITY • health requirements for the use of work equipment workers at the work of Directive 2009/104/CE of European Parliament and of the • Supplier disclaims any liability if: Council of 16 September 2009. • Product failure or deformation result from improper installation •...
-
Page 5: Operator
02. OPERATOR TECHNICAL SPECIFICATIONS INSIDE THE PACKAGE On the package you will find the following kit components: CHAINLIFT 01 • 01 Chainlift 06 • 01 Photocell MF30 • Product power supply 230 V 50/60Hz 02 • 02 FALK controller 07 • 02 key unlock •... - Page 6 03 • Fill the hole with concrete and smooth the top where you will fix the column. 04 • Apply the column with the screws to the concrete base. You must ensure that the column is level (use a level). INSTALLATION OF THE GUTTER CHAINLIFT HEMBRAS TORNILLOS HEMBRAS VÃO...
-
Page 7: Installation
03. INSTALLATION 03. INSTALLATION INSTALLATION OF THE CHAIN INSTALLATION OF THE GUTTER TO THE GROUND 11 • Cut the gutter from the floor as far After installing the two columns, proceed as follows to install the chain: as the span, and install it under the ground with cement. -
Page 8: Components Test
04. COMPONENTS TEST SCHEMES FOR TESTS To detect if the failure is in the control board or in the motor, it is necessary to perform tests with a direct connection to a 230V power supply. In the diagrams below, it is shown how this connection should be made and how to interleave the different components wires. -
Page 9: Troubleshooting
05. TROUBLESHOOTING FINAL CONSUMERS AND SPECIALIZED TECHNICIANS INSTRUCTIONS Problem Procedure Behavior Behavior II Discovering the origin of the problem • Make sure you have 1 • Open control board and check 3 • Disconnect the motor from 4 • If the motor works, problem is 5 •...
Need help?
Do you have a question about the CHAINLIFT and is the answer not in the manual?
Questions and answers