Slamtec SDP Mini Quick Start

Advertisement

SQ103 SLAMWARE SDP Mini Quick Start
On this page, we will introduce how to connect the SDP Mini to our mobile applications and computer. If you are a new comer for SLAMTEC
products, it's fine to start from here.
On this page

Step 1: put batteries in

Step 2: launch SDP Mini
Step 3: control on mobile
application
Step 4: download and use
SLAMWARE SDK
Related pages
Step 1: put batteries in
SDP Mini requires only 8 AA batteries to run well. After receiving the product, please put batteries in the battery holder first. The steps for taking
out the battery holder are as below:
1.
loosen the two thumb screws next to the battery holder anti-clockwise;
2.
remove the protective board;
3.
pull out the battery holder carefully and put batteries in;
4.
push the battery holder and protective board back, and then  tighten the screws clockwise to fix the battery holder
Download

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SDP Mini and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Slamtec SDP Mini

  • Page 1 SQ103 SLAMWARE SDP Mini Quick Start On this page, we will introduce how to connect the SDP Mini to our mobile applications and computer. If you are a new comer for SLAMTEC products, it's fine to start from here. Download...
  • Page 2 Step 2: launch SDP Mini Turn the switch(SW1 interface on the Breakout 3.0 of SDP Mini) on to launch the SDP Mini, then the indicator D1 lights up red and the buzzer buzzes a few times. The RPLIDAR starts to rotate after 30 seconds which indicates the device launch successfully.
  • Page 3 Please connect to the SLAMWARE-XXXXXX via WiFi(you can also connect the SDP Mini to your PC via network cable, in this condition, the network adapter on the PC should be set as DHCP mode). Then open the tool Robot Studio...

Table of Contents