Porsche 718 Cayman GT4 Owner's Manual page 39

Air-Conditioning (2-Zone Automatic Air Conditioning)
General information
A
B
C
D
E
F
G
H
I
J
K
L
M
Fig. 9: Air-conditioning control panel
N
Depending on various factors like sunlight or air
quality, the air conditioning system adjusts the
O
preset interior temperature, air distribution and air
P
quantity fully automatically in automatic mode.
The temperature can be set individually for the left
Q
and right air-conditioned areas.
R
Automatic mode is deactivated as soon as the
settings are adjusted manually. In this case,
S
automatic air conditioning continues to regulate the
T
functions that have not been changed manually.
U
Information
V
Additional air conditioning settings can be made on
the multifunction display:
W
f Please see chapter „Setting air conditioning" on
X
page 244.
Y
Z
36
Keeping the sensors clear
Fig. 10: Interior temperature sensor
To avoid impairing the performance of the air-condi-
tioning system:
e Do not cover or tape over the interior temperature
sensor for the air-conditioning.
Cooling function
The cooling function cools and dries the air.
Information
– The cooling function can switch off briefly to
ensure sufficient engine cooling when the engine
is operating under extreme load.
It switches off automatically at temperatures
below approx. 36 °F (2 °C) and cannot be
switched on, even manually.
– The cooling function operates most effectively
with the windows closed. If heat accumulates in
the passenger compartment, briefly open the
windows to ventilate the interior.
– Temporarily setting the temperature to a lower or
higher value does not cool or heat the vehicle
interior to the desired temperature more quickly.
– Depending on the outside temperature and
humidity, condensation may drip from under the
vehicle. This is quite normal and is not a defect.
– If the battery voltage is too low, the fresh-air
blower and cooling functions are initially
restricted and then switched off.
Switching automatic mode on
The air-conditioning zones can be switched to
automatic mode.
e Press button
on the air-conditioning
control panel.
AUTO appears on the air-conditioning display.
Air temperature, quantity and distribution are
automatically controlled.
Information
If necessary, the automatic system can be controlled
manually. The manual setting is retained until the
relevant function button is pressed again or until
button is pressed.