Checking The Rubber Grip - Husqvarna TC 250 2021 Owner's Manual

11.42

Checking the rubber grip

SERVICE WORK ON THE CHASSIS 11
Main work
–
Check throttle cable routing.
The throttle cable must be routed along the back of the
handlebar, to the right of the frame, above the fuel tank
bracket, and to the carburetor. The throttle cable must be
secured on the fuel tank bracket with a rubber strap.
» If the throttle cable routing is not as specified:
–
Correct the throttle cable routing.
F02285-10
Finishing work
–
Install the fuel tank.
–
Install the right side cover. (
–
Mount the seat. (
–
Install the air filter box cover. (
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve
or the throttle tube.
401197-01
» If a rubber grip is damaged or worn
–
Change the rubber grip.
–
Check that screw
Guideline
Screw, fixed
grip
A
Diamond
F02286-10
( p. 65)
p. 64)
p. 59)
p. 59)
1
is firmly seated.
M4 5 Nm (3.7 lbf ft)
must be located at the top.
®
Loctite 243™
73