Adding The Gear Oil - Husqvarna TC 250 2021 Owner's Manual

16.3

Adding the gear oil

Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
Gear oil must only be topped up when the engine is cold.
SERVICE WORK ON THE ENGINE 16
Main work
–
Remove gear oil drain plug
–
Remove filler plug
–
Let the gear oil drain fully.
–
Thoroughly clean the gear oil drain plug with magnet.
–
Clean the sealing surface on the engine.
–
Mount and tighten gear oil drain plug
and a new seal ring.
Guideline
Gear oil drain plug
with magnet
–
Fill in gear oil.
Gear oil
–
Mount and tighten filler plug
Danger
K01300-10
Danger of poisoning Exhaust gases are toxic and
inhaling them may result in unconsciousness and
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check for leaks.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Park the motorcycle on a level surface.
Main work
–
Remove gear oil level monitoring screw
K01299-10
1
with magnet.
2
with the O-ring.
1
with the magnet
M12x1.5 20 Nm (14.8 lbf ft)
0.8 l (0.8 qt.) Engine oil (15W/50)
( p. 127)
2
with the O-ring.
p. 110)
1
.
111