Kwikset kevo Installation And User Manual

61063 / 01
Installation and User Guide
Required Tools
Ruler Phillips Head Screwdriver
Additional Accessories
(depending on application)
Hammer Wood block
1 Prepare door and check dimensions
If drilling a new door, use the supplied template and the complete
door drilling instructions available at www.kwikset.com/doorprep.
Measure to confi rm that the hole in the door
A
is either 2-1/8" (54 mm) or 1-1/2" (38 mm).
2-1/8"
54 mm
or
1-1/2"
38 mm
Note: Additional door preparation may be
required for doors with 1-1/2" (38 mm) holes.
Consult the deadbolt drilling instructions at
www.kwikset.com/doorprep.
2
Install latch and strike
A
Is the door edge chiseled?
YES
or
chiseled
Use latch "A". Extend
the latch bolt as shown.
A
You can view the
Kevo installation video
online by scanning
the code to the right
or by visiting
www.kwikset.com/
kevo/support
Measure to confi rm that the backset is either
B
2-3/8" or 2-3/4" (60 or 70 mm).
2-3/8" or 2-3/4"
60 or 70 mm
B
Hold the latch in front of the door hole, with the latch face fl ush
against the door edge.
NO
not
chiseled
Use latch "A2". Extend
the latch bolt as shown.
A2
C
Are the latch holes centered in the door hole?
No adjustment is required.
Proceed to next step.
Parts in the Box
Latch and Strike
A
A2
C
D
Measure to confi rm that the hole in the door
C
edge is 1" (25 mm).
A A2
YES NO
or
Rotate latch face as
shown to extend latch.
A
180°
A2
180°
Exterior Assembly Interior Assembly
B K
E
F
G
H
Q
Kevo Fob
R
J
Measure to confi rm that the door is either
D
1-3/8" or 1-3/4" (35 mm or 44 mm) thick.
1"
25 mm
D
Which latch are you installing?
Latch "A"
or
A
C (2x)
E
Install strike on the door frame.
M
N
L
P
S
1-3/8" or 1-3/4"
35 mm or 44 mm
Latch "A2"
A2
A2
wood
block
D (2x)
B
door frame