Table of Contents
Advertisement
CCU | User Manual
7.2 Precautions for Installation
The product must be installed by skilled and instructed
personnel only. Personnel scheduled to be trained,
familiarized and instructed or to take part in a general
training course may only work with the product under
the supervision of an experienced person.
Electro Static Discharge (ESD) precautions
•
should be taken while installation of
CCU.
The CCU should be installed on the vehicle in
•
accordance to the instructions in the Installation
manual. Refer to the annexure for guidelines.
Follow the specifications and instructions of the
•
vehicle manufacturer.
During vehicle installation, switch the gearbox to
•
neutral and actuate the hand brake. Secure the
vehicle against rolling away with brake wedges.
Switch
off
•
connect/disconnect the CCU to/from the OBD
interface.
Do not drop the CCU. It may lead to damage or
•
malfunctioning of the product.
Install the CCU at a location that
•
Does not impair any of the safety devices
o
(such as the main airbag, knee airbag and
steering).
Does not impair the driver of his/her
o
driving.
At least 20 cm away from any human
o
contact and fastened with sufficient
space.
Prevent any contact of the CCU, OBD
o
connection cable or wiring harness with
hot components.
The functioning of other lines or cables
o
is not impaired, or they are not clamped.
The CCU should only be removed or
o
Robert Bosch Engineering and Business Solutions Private Limited | September 19, 2020
the
ignition
when
8 Scope for Delivery
The scope of delivery includes:
you
Note: Check the product for any damages. Never use a
damaged product. If you have any complaints, please
contact the service technician.
9 Legal Requirements
iTRAMS CCU product family is undergoing
Electromagnetic and Radio Frequency conformance
tests and validations in different regions.
replaced by an authorized service
personal.
On-board Unit (CCU)
Installation Manual
The voltage and current rating of the wiring
harness must be greater than the voltage and
current rating mentioned in the technical
specifications.
It is recommended to have a fast blow fuse
with below rating in series on the positive
power supply line at vehicle wiring harness.
5A for 12/24V applications
If one of the following situations arise, get the
equipment checked by service technician:
The wiring harness or connector is
damaged.
Liquid
has
penetrated
equipment.
The equipment has been exposed to
moisture.
The equipment does not work as per
specifications.
The equipment has been dropped and
damaged.
The equipment has been exposed to
elevated temperatures (beyond storage
specifications).
9 | 20
into
the
Advertisement
Table of Contents
