Best Practice For Wiring Routing - Bosch CU-304-0503 User Manual

CCU | Operations Manual
7

Best Practice for Wiring Routing

Due to the effects of gravity passing water through the wires, the CCU should be packaged higher than any wire

end or splice in the harness.
Measures should be taken to prevent water from collecting around the wiring harness. Plastic wire

covering/protection should allow water to drain from harness.
Wiring should be routed away from water drainage areas. Wires that are routed around sharp edges or that can

be damaged from stone impingements should be protected
Water in the wiring harness can cause interference on various signal wires due to poor wiring insulation.

Wires splices and ground eyelets must be located away from direct contact with high pressure cleaner.

Any wire end terminating in a splash water area should be orientated so that the wire end is pointing down.

Robert Bosch Engineering and Business Solutions Private Limited | September 19 2020
19 | 20