Toro Greensmaster Flex 21 Installation Instructions

Throttle Bracket Kit
Greensmaster
Part No. 108–9404
1. Park the mower on a level surface. Make sure the
engine is OFF. Remove the high tension lead from the
spark plug.
2. Move the throttle and traction/reel controls to the
disengaged position.
3. Remove the screw and lock washer securing the brake
lever to the brake bracket (Fig. 1).
4. Remove the screw, spacer and nut securing the brake
cable to the brake lever (Fig. 1). Allow the brake lever
to hang in the slot in the console.
3
Figure 1
1. Brake lever
2. Brake control bracket
5. Remove the screw and washer securing the pin of the
traction control rod handle to the traction control
(Fig. 2). When removing the screw and washer from
lever, make sure to account for the detent ball and
spring which will fall out of the lever.
6. Remove the socket head screw and nut mounting the
traction control rod handle to the traction control lever
(Fig. 2).
W 2006 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
)
Flex 21
1
2
3. Brake cable
Installation Instructions
1
Figure 2
1. Traction control rod handle
2. Traction control lever
3. Pin
7. Remove the (4) screws securing the console to the
handle (Fig. 3). Rotate the left side of the console
downward until the right side can be maneuvered over
the traction control handle and away from the handle.
1
Figure 3
1. Console
8. Remove the cable ties securing the cables to the
control bracket.
1
Form No. 3353–386 Rev. A
3
2
5
4
4. Screw & washer
5. Spring
6. Detent ball
All Rights Reserved
Printed in the USA
6