Service And Repairs; Interlock Switch - Toro Greensmaster Flex 21 Service Manual

Service and Repairs

NOTE: See the Kawasaki FE120 Service Manual in
Chapter 3 – Engine for more engine component repair
information.

Interlock Switch

Adjustment
1. Make sure the engine is OFF and the traction lever
is in the NEUTRAL position.
2. Loosen interlock switch mounting fasteners.
3. Hold traction lever against the neutral stop (Fig. 6).
4. Place a .032" (.8 mm) thick shim between the traction
lever and the interlock switch.
5. Tighten interlock switch mounting fasteners. Re-
check gap. The traction lever must not contact the
switch.
6. Engage traction lever and verify that the switch
opens (no continuity).
Removal
1. Disconnect switch from the wires leading from the In-
terlock module.
2. Remove fasteners and spacers that mount switch to
control bracket on handle (Fig. 7). Remove switch from
bracket.
Installation
1. Position switch to control bracket with fasteners and
spacers.
2. Adjust interlock switch (see Adjustment above) as
necessary.
3. Connect switch to wires from the interlock module.
Electrical System
2
3
1. Traction lever
2. Neutral stop
7
8
1. Interlock switch
2. Control bracket
3. Handle
4. Cap screw
Page 5 – 8 Rev. C
1
Figure 6
3. Interlock switch
4. Clearance
3
2
5
6
1
4
Figure 7
5. Spacer
6. Flat washer (early units)
7. Locking nut
8. Console
Greensmaster Flex 21
4