Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
WARNING
The edges of the cutting cylinder and bottom
blade are sharp, and contact with them can
cause injury.
Take care to avoid the sharp edges of the
cutting cylinder and bottom blade when lifting
or working on the cutting unit.
WARNING
The cutting unit is heavy; lifting the cutting
unit improperly could cause injury.
Use suitable lifting equipment when removing
the cutting unit from the carton and during
installation.
1
Preparing the Machine
No Parts Required
Procedure
1.
Move the machine to a level surface.
2.
Lower the cutting units completely to the ground.
Description
No parts required
No parts required
No parts required
No parts required
Pin
Cap-head screw
Plain washer
Spring washer
No parts required
Qty.
–
Prepare the machine.
–
Inspect the cutting unit.
Convert the cutting unit from left to right
–
configuration.
–
Adjust the hand-wheel assemblies.
1
2
Install the cutting units to the machine.
2
2
–
Lubricate the cutting units.
3.
Shut off the engine and remove the key.
4.
Engage the parking brake.
5.
Ensure that there is no pressure in the hydraulic
system.
6.
Set the battery-disconnect switch to the O
position.
2
Inspecting the Cutting Unit
No Parts Required
Procedure
1.
Check that all parts are delivered correctly.
2.
Remove the cutting unit from the carton and
check that all loose items have been supplied
correctly.
3.
If any items are missing contact your authorized
Toro distributor.
4
Use
FF
Advertisement
Table of Contents
