Table of Contents
Advertisement
This product complies with all relevant European
directives. For details, please see the Declaration of
Incorporation (DOI) at the back of this publication.
Introduction
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
You may contact Toro directly at www.Toro.com
for product safety and operation training materials,
accessory information, help finding a dealer, or to
register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an authorized Toro
distributor and have the model and serial numbers of
your product ready. The model and serial numbers
are located on the left side of the cutting unit. Write
the numbers in the space provided.
Model No.
Serial No.
© 2017-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure
1), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
1. Safety-alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
Contents
Safety ....................................................................... 3
Safety and Instructional Decals .......................... 3
Setup ........................................................................ 4
1 Preparing the Machine..................................... 4
2 Inspecting the Cutting Unit ............................... 4
Right Configuration ......................................... 4
4 Adjusting the Hand-Wheel Assemblies ............ 5
Machine .......................................................... 6
6 Lubricating the Cutting Unit .............................. 6
Product Overview ..................................................... 7
Specifications .................................................... 7
Attachments/Accessories ................................... 7
Operation .................................................................. 8
Operating the Cutting Unit .................................. 8
Adjusting the Pivot Knuckle ................................ 8
Adjusting the Height of Cut ................................. 8
Clearing the Cutting Cylinders ............................ 9
Maintenance ........................................................... 10
Contact ......................................................... 10
Greasing the Cutting Unit.................................. 10
Adjustment.....................................................11
Tension ..........................................................11
and Bottom Blade ......................................... 12
Backlapping the Cutting Unit............................. 13
Grinding the Cutting Unit................................... 13
Replacing the Bottom Blade ............................. 14
2
Figure 1
Contact us at www.Toro.com.
Printed in the UK
All Rights Reserved
g000502
Advertisement
Table of Contents
