Interface Connection; Speakers And Audio - Elo TouchSystems 1919L User Manual

Interface Connection

Note: Before connecting the cables to your touchmonitor and PC, be sure that the computer and touchmonitor
are turned off.
1. Connect DC cable of the power brick to the monitor and the other end through AC power cable
to the AC outlet.
2. Connect one end of either the touchscreen serial (RS232) cable or the touch screen USB cable
(but not both) to the rear side of the computer a nd the other end to the LCD monitor. Tighten by
turning the two thumb screws clockwise to ensure proper grounding.
3. Connect one end of the video cable to the rear side of computer a n d the other to the LCD monitor.
Tighten by turning the two thumb screws clockwise to ensure proper grounding.
4. Connect one end of the audio cable to the rear side of computer and the other to the LCD
monitor.
5. Facing the monitor, press the power button located on the underside of the botom-right corner
of the monitor.

Speakers and Audio

The touchmonitor includes two built-in speakers. To use the speakers, plug in the audio cable to
the Audio Input port and connect the other end to your computer.
To use headphones, plug in the hea dphones to the Audio Output port shown a bove. When
headphones are connected, the sound plays through the headphones only.
The volume and muting of the sound can be adjusted by using the "Audio" choice from the On-
Screen Display (OSD) Control panel menu as described on page 3-19.
1 2 2
Serial Cable
USB Cable
Power Brick
Headphone Cable
3
4
Audio Cable
VGA Cable
2-9