Table of Contents
Advertisement
Getting started
Battery installation & charging
Install the battery as shown below. After installing the battery, you can make
and receive short calls, but replace the handset in the telephone base or
charger when not in use. For optimal performance, charge the handset battery
for at least 6 hours before use. When fully charged, the handset battery
provides approximately five hours of talk time or three days of standby time.
If the battery is depleted, it may take approximately four minutes to charge
the handset before it can resume screen display. The screen will continue to
display LOW BATTERY until the battery has charged for approximately one
hour.
Step
Press the depression
and slide the battery
compartment cover
downwards.
(if necessary)
Step
4
Charge the handset by placing it face up in the
telephone base or charger. The CHARGE light will
be on when charging.
IMPORTANT INFORMATION
Use only the supplied rechargeable battery or replacement battery (model BT800). To order, visit our
www.telephones.att.com
website at
1 (866) 288-4268.
Step
2
Plug the battery securely
into the connector inside
the handset battery
compartment, matching
the color-coded label.
Insert the supplied battery
with the label THIS SIDE
UP facing up as indicated.
1 (800) 222-3111.
or call
Step
3
Align the cover flat
against the battery
compartment
cover, then slide
it upwards until it
clicks into place.
In Canada, dial
Advertisement
Table of Contents
