Usb-Input Display; The Shifter (1); The Shifter (2); How The Electrical Support Work - Lacros AMBLING A200 Original Manual

CE ORIGINAL MANUAL LACROS AMBLING A200(XL)/A400(XL)
VERSION CE 1.4 EN

USB-input display

Below the display you will find a USB-port (A) where you can, for
example, charge your telephone or navigation while cycling. This
charging only works when the display is on.
Press the "M" key and the "+" for 2 seconds to activate the USB.

The Shifter (1)

The shift mechanism of the derailleur is located on the steering
wheel, which has a (A) and (B) Finger control. By pressing (B) you
switch up, by pushing (A) you switch down.
Note: You must keep pedaling while switching gears. However, it is
better for the gears that you do not put excessive force on the
pedals during the shift.

The Shifter (2)

The shift mechanism of the derailleur is located on the steering
wheel, which has a (B) and (C) thumb control. By pressing (B)
you switch up, by pushing (C) you switch down.

How the electrical support work

The bicycle use PAS (pedal support) through a magnet-rotation sensor. This means that the electrical support
starts the moment the pedals go around. In addition, there is a thumb lever on the left side of the handlebar
to activate the maximum support quickly and easily (which is independent of the motor support 1 to 9). As
long as you continue to hold this thumb lever forward (while pedaling), the motor will give the maximum
support, similar to support position 9 on the display.
Support is interrupted when:
- You stop pedaling.
- The brakes are used.
- Release the thumb lever if you use it.
10