Judging Error Displays (When Numeric Value Is Displayed) - Panasonic FP2 S-LINK Technical Manual

7.3.2 Judging Error Displays (When Numeric Value is Displayed)

Only a numeric value is displayed.
Example:
An error has occurred at the address that is displayed.
There is only one address where an error has occurred.
Turn off the power supply to the S-LINK, and correct the error. Then turn on the power supply to the S-
LINK.
A numeric value and decimal points are displayed.
Example:
More than one error has occurred.
The numeric value that is displayed indicates the smallest address of the addresses where errors have
occurred.
To check error addresses other than the one that is displayed, set the "RUN/CHK." selector switch to the
"CHK." position, and press the system SET button.
Turn off the power supply to the S-LINK, and correct the error. Then turn on the power supply to the S-
LINK.
Note:
• Set the "RUN/CHK." selector switch to the "CHK." position before pressing the system SET button.
• If the RUN/CHK. selector switch is set to the RUN position and the SET switch is pressed while an
error is in effect, only the number of S-LINK devices that can be confirmed at that point are stored in
the memory. There is a possibility that S-LINK devices where the error has not been corrected will not
be recognized (if this happens, they will not be a target for the check).
7-5