Cofirming Connected Units; Confirming All Recognized Addresses - Panasonic FP2 S-LINK Technical Manual

5.5 Cofirming Connected Units

5.5.1 Confirming All Recognized Addresses

When the procedures of address recognition for S-LINK devices are completed, the user can confirm the
addresses of the S-LINK I/O devices that have been recognized.
This is useful in preventing problems such as erroneous settings where the same address may have
been allocated to two or more S-LINK I/O devices.
Note:
If the same address is assigned to multiple devices, the S-LINK I/O devices will be recognized as a
single device.
Procedure
1. Set the RUN/CHK. selector switch to the "CHK." position.
The S-LINK unit switches to check (CHK.) mode.
The number of recognized connected devices blinks.
(At this time, even if booster is connected, it is not included in the number of connected devices.)
2. Press the system SET button.
The smallest of the recognized addresses is displayed. After this, each time the system SET button is
pressed, the recognized addresses are displayed successively in the ascending order. (only the first
set address in case of multi-channel S-LINK I/O devices)
After the last recognized address is displayed, the number of recognized connected devices is
displayed once again, and then, the display of the addresses is repeated. Further, by pressing the
system SET button continuously for some time, the recognized addresses can be displayed
successively.
[Example]
Note:
After confirmation has been made, always set the RUN/CHK. selector switch back to the "RUN" position.
The display reverts to the normal "
5-6
" display.