Table of Contents
Advertisement
PRI-EOM
Procedure Interrupt EOM
Command similar to EOM. Operation by an operator is necessary.
PRI-MPS
Procedure Interrupt MPS
Command similar to MPS. Operation by an operator is necessary.
PRI-EOP
Procedure Interrupt EOP
Command similar to EOP. Operation by an operator is necessary.
DCN
Disconnect
Commands to disconnect the FAX line and to connect the telephone line. Reply from the
other side is not necessary.
RR
Receive Ready
Informs that the FAX is ready to receive documents and requests for data to set the
reception mode. (ECM mode)
RNR
Receive Not Ready
Informs that the Fax Unit is not in the receivable state. (ECM mode)
PPR
Partial Page Request
Informs that a part of page (ECM block) has not been received correctly and specifies the
frame data (binary signal) which need to be corrected in the FIF information.
PPS
Partial Page Signal
Informs that a part of page (ECM block) or one page has been transmitted. (ECM mode)
CTC
Continue to Correct
Replies to the 4th PPR which requests to correct the image signal; informs that the
transmitting station will continue to correct the frame data. (ECM mode)
CTR
Response for Continue to Correct
Replies to CTC and informs that the receiving station has received and accepted the CTC.
(ECM mode)
EOR
End of Retransmission
Informs that the transmitting station has completed the correction of the error frame data
(binary signal) of the previous ECM block. (ECM mode)
ERR
Response for End Retransmission
Replies to EOR and requests to transmit the image signal of the next ECM block. (ECM
mode)
RTP
Retrain Positive
Informs that the message has been received completely and that the subsequent message
can be continued after receiving the synchronization signal and CFR signal.
CRP
Command Repeat
Requests to resend all the commands including optional frames because the preceding
command has been received incorrectly.
GD-1370
DIALING/COMMUNICATION CONTROL
© 2016-2020 Toshiba Tec Corporation All rights reserved
3 - 6
Advertisement
Table of Contents
