Table of Contents
Advertisement
(3)
FCF
•
Binary signals and functions for FCF
NSF
Non-Standard Facility
Informs that the receiving station (machine) has a non-standard facility.
NSC
Non-Standard Facility Command
Commands to transmit using the non-standard facility which is selected corresponding to
NSF (i.e., Polling etc.).
NSS
Non-Standard Facility Setup
Commands to transmit using the non-standard facility which is selected corresponding to
NSF or NSC.
CSI
Called Subscriber Identification
Provides the telephone number of the called station. Used to check the identity of the called
station.
CIG
Calling Subscriber Identification
Provides the telephone number of the calling station. Used to check the identity of the
calling station (Polling, etc.).
TSI
Transmitting Station Identification
Provides the telephone number of transmitting station. Used to check the identity of the
transmitting station.
DIS
Digital Identification Signal
Informs that the receiving station (machine) has a standard facility (G3/G2).
DTC
Digital Transmit Command
Commands to transmit using the standard facility which is selected corresponding to DIS
(i.e., Polling, etc.).
DCS
Digital Command Signal
Commands to transmit using the standard facility which is selected corresponding to DIS or
DTC.
SUB
Sub-address
Indicates that the FIF information is a sub-address in the domain on the call-in side.
SEP
Select Polling
Indicates that the FIF information is a sub-address for the polling mode.
PWD
Password
Indicates that the FIF information is a password for the polling mode in a reception.
Indicates that the FIF information is a password for transmission in a transmission.
CFR
Confirmation of Reception
Informs that the FAX is ready to receive data.
FTT
Failure to Train
Informs that the TCF signal has not received correctly and requests the re-training.
EOM
End of Message
Informs that the 1st page has been transmitted and there is the next page; commands to
return to the beginning of the phase B.
MPS
Multi-page Signal
Informs that the 1st page has been transmitted and there is the next page; commands to
return to the beginning of the phase C.
EOP
End of Procedure
Informs that a document has been transmitted and there is no more pages.
MCF
Message Confirmation
A reply to MPS, EOM or EOP; informing that image signals have been received correctly
and the Fax Unit is ready to receive data.
RTN
Retrain Negative
Informs that a document has not been received correctly; requests for the retraining or
phase synchronization to receive the next page.
PIP
Procedure Interrupt Positive
Informs that the image signals have been received correctly and requests the operator's
reply by telephone or to return to the beginning of the phase B to continue the
communication (i.e., CALL Request, etc.).
PIN
Procedure Interrupt Negative
Informs that the image signals have not been received correctly and requests for operator's
reply by telephone or to return to the beginning of the phase B to continue the
communication.
© 2016-2020 Toshiba Tec Corporation All rights reserved
DIALING/COMMUNICATION CONTROL
3 - 5
3
GD-1370
Advertisement
Table of Contents
