Safety Information; Intended Personnel; Information; Warnings, Cautions And Notes - Control Techniques EMERSON SPM Installation Manual

Power selector module
Table of Contents

Advertisement

1

Safety information

1.1

Intended personnel

This guide is intended for personnel who have the necessary training and experience in
system design, installation, commissioning / start up and maintenance.
1.2

Information

This guide contains information covering the identification of the SPM Power Selector
Module, control terminal layout for installation, connections for the SPM Power Selector
Module to the Unidrive SPM, parameter details and diagnostic information.
1.3

Warnings, cautions and notes

A Warning contains information which is essential for avoiding a safety hazard.
WARNING
A Caution contains information which is necessary for avoiding a risk of damage to the
product or other equipment.
CAUTION
A Note contains information which helps to ensure correct operation of the product.
NOTE
1.4

Electrical safety - general warning

The voltages used in the drive can cause severe electrical shock and/or burns, and
could be lethal. Extreme care is necessary at all times when working with or adjacent to
the drive.
Specific warnings are given in the relevant places throughout this guide.
1.5

System design and safety of personnel

The STOP and SAFE TORQUE OFF functions of the drive do not isolate dangerous
voltages from the output of the drive or from any external option unit. The supply must
be disconnected by an approved electrical isolation device before gaining access to the
electrical connections.
With the sole exception of the SAFE TORQUE OFF function, none of the drive
functions must be used to ensure safety of personnel, i.e. they must not be used
for safety-related functions.
Careful consideration must be given to the functions of the drive which might result in a
hazard, either through their intended behavior or through incorrect operation due to a
fault. In any application where a malfunction of the drive or its control system could lead
to or allow damage, loss or injury, a risk analysis must be carried out, and where
necessary, further measures taken to reduce the risk - for example, an over-speed
protection device in case of failure of the speed control, or a fail-safe mechanical brake
in case of loss of motor braking.
SPM Power Selector Module Installation Guide
Issue: 2
www.controltechniques.com
5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EMERSON SPM and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

0471-0144-02

Table of Contents