Table of Contents
Advertisement
CHAPTER 2 STANDARDS AND ADJUSTMENTS
A. Adjusting the Images
1
Adjusting the Image Leading Edge Margin [3] No. 305
Select [3] No. 305 (leading edge margin adjustment) in service mode, and make
adjustments so that the image leading edge margin is 2.5 ±1.5 mm when the Test Sheet
is copied in Direct.
Reference:
2nd side of 2-sided copy: 2.5 ±2.0 mm
Making Adjustments
1) Start [3] in service mode, and select No. 305 using the keypad.
•
The display indicates '305'.
2) Press the OK key.
•
The indicator indicates the stored setting.
3) Using the keypad or the Zoom keys, change the setting.
•
The indicator flashes the setting.
•
To enter a negative setting, press the % key.
4) Press the OK key.
•
The new setting is stored.
•
The indicator stops flashing and remains on.
•
A press on the Copy Start key starts copying.
5) To change the settings in succession, repeat steps 3) and 4).
6) Press the Clear key to return to item selection.
The settings and the image positions have the following relationships:
•
For each '1' in the setting, the margin width changes about 0.4 mm.
•
A higher setting decreases the margin width.
CHAPTER 2 STANDARDS AND ADJUSTMENTS
2.5 ±1.5 mm
Figure 2-1
2
2-1
Advertisement
Table of Contents
