Table of Contents
Advertisement
F. Electrical System
1
Registering the Cassette/Multifeeder Paper Width Basic Setting [4]
Perform the steps for the following:
•
If you have replaced the paper width detection VR (including the multifeeder) of
the copier.
•
If you have adjusted the cassette front/rear registration.
For each of the cassettes 1 and 2, paper width basic setting registration must be
executed under both 'STMTR' and 'A4R'; for the multifeeder, registration must be
executed under 'A6R', 'A4R', and 'A4'.
a. Cassette 1
1) Start [4] in service mode, and select No. 413 using the keypad.
•
The indicator indicates '413'.
2) Press the OK key.
•
The indicator indicates 'S-r'.
3) Slide out the cassette 1, and set the paper width guide plate inside the cassette to
'STMTR'.
4) Set the cassette to the copier.
5) Press the OK key.
•
The indicator indicates 'A4r'.
6) Slide out the cassette 1, and set the paper width guide plate inside the cassette to
'A4R'.
7) Set the cassette to the copier.
8) Press the OK key.
•
The indicator indicates 'S-r'.
9) Press the Clear key.
•
The indicator indicates '413'.
You may make the same adjustment for cassette 2. (No.414 in service mode [4])
CHAPTER 2 STANDARDS AND ADJUSTMENTS
2-37
Advertisement
Table of Contents
