Brodit 736102 Installation Instructions

4 October, 2021, www.brodit.com, © 2021 Brodit AB
Product 736102
736102 Holder with lock. Active holder for fixed installation, with tilt swivel. 2 keys included. With USB Host.
This holder is to be used when you want to secure your unit and still have it easy accessable.
The active holder is to be connected inside the dashboard. It provides a discreet and neat installation without any
cables hanging over the interior. Safe and convenient! 12/24 Volt. The product is E-approved. Connect the power
cable with a 2 A fuse. 1 A charger. Charging via pogo plug. Professional installation recommended.
Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a
lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for
maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the
Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.
The holder is also perfect for use in stores, at exhibitions and any place where you want to use your Tab Active 2
without having it easy removable. The holder is equipped with a lock. In order to remove the Tab Active from the
holder you need the key, two keys are included. The holder is mounted onto a tilt swivel. This mean that you can
adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and
landscape mode by turning the holder into desired position.
Tablets should not be installed onto a car's dashboard if blocking the view or key controls. ProClip is designed for
use with smaller devices like smartphones. If you want to place a tablet onto a dashboard, each combination of
tablet-car must be examined in detail by yourself in order to determine if such an installation is possible in the
specific case. Brodit will not give any recommendations for such installations. An installation of a tablet onto a
vehicle's dashboard is always done on the customer's own responsibility. Brodit recommends using tablets on the
car's headrest, installed onto a Brodit headrest mount.
EAN: 7320287361025
Item no 736102 fits:
Panasonic FZ-L1 (For all countries)