Type Plate; Transport, Packaging, Storage; Delivery; Packaging - Holzstar DB 900 Operating Instructions Manual

Transport, packaging, storage

4.1 Type plate

Fig. 2: Type plate DB 1100
5 Transport, packaging, storage

5.1 Delivery

After delivery, check the lathe for visible transport da-
mage. If you discover any damage to the lathe, report it
immediately to the transport company or dealer.
Transport
Improper transport is accident-prone and can cause da-
mage or malfunctions for which we do not grant any liabi-
lity or guarantee.
Transport the scope of delivery secured against shifting
or tilting with a sufficiently dimensioned industrial truck to
the installation site.
WARNING!
Severe or fatal injuries may occur if parts of the
machine tumble or fall down from the
truck, pallet truck or from the transport vehicle.
Follow the instructions and information on the trans-
port box.
Note the total weight of the machine. The weight of
the machine is indicated in the "Technical data" of the
machine. When the machine is unpacked, the weight
of the machine can also be read on the rating plate.
Only use transport devices and load suspension gear
that can hold the total weight of the machine.
WARNING!
The use of unstable lifting and load suspension
equipment that might break under load can cause
severe injuries or even death. Check that the lifting
and load suspension gear has sufficient load-bea-
ring capacity and that it is in perfect condition.
Observe the accident prevention regulations issued
by your Employers Liability Insurance Association or
other competent supervisory authority, responsible
for your company.
Fasten the loads properly.
8
General risks during internal transport
The device may be lifted unsecured by a maximum
of 2cm.
Employees must be outside the danger zone, the
reach of loads.
Warn employees and, if necessary, advise employ-
ees of the hazard.
Devices may only be transported by authorized and qua-
lified persons. Act responsibly during transport and al-
ways consider the consequences. Refrain from daring
and risky actions.
Gradients and descents (e.g. driveways, ramps and the
like) are particularly dangerous. If such passages are
unavoidable, special caution is required.
Before starting the transport check the transport route for
possible danger points, unevenness and disturban-ces
as well as for sufficient strength and load capacity.
Danger points, unevenness and disturbance points must
be inspected before transport. The removal of danger
spots, disturbances and unevenness at the time of trans-
port by other employees leads to considerable dangers.
Careful planning of internal transport is therefore essen-
tial.
Transport with a forklift/lift truck:
For shipping, the device packed in a wooden box is deli-
vered on a pallet so that it can be transported with a
forklift truck or pallet truck.

5.2 Packaging

forklift
All of the machine's packaging materials and packing
aids are suitable for recycling and must always be dispo-
sed of using material-based recycling systems.
Packaging materials made of cardboard must be shred-
ded and disposed of as part of waste paper recycling.
The foils are made of polyethylene (PE), padding is
made of polystyrene (PS). Dispose of these substances
at a recycling centre or hand them over to the relevant
waste disposal company.

5.3 Storage

Let the lathe cool down completely. Storage the thoro-
ughly cleaned lathe in a dry, clean and frost-free environ-
ment.
Environmental temperature range: -25 °C to +55 °C.
WARNING: DANGER OF TIPPING
DB-Series | Version 3.09