Table of Contents
Advertisement
Note
If a sunshade roof is fitted, heat must be prevented from building up.
If a temperature-monitoring device is fitted, a warning signal must be emitted when the maximum
permitted oil-sump temperature is reached.
If the maximum permitted oil-sump temperature is exceeded, the drive must be shut off.
Such shutting off may cause the operator's plant to stop.
NOTICE
Material damage
Risk of damage to the gear unit caused by falling objects, heaping over, welding work or insufficient
fastening.
The operator must ensure the following:
– The gear unit must be secured against falling objects and heaping over.
– No welding work must be done at all on the drive system.
– The gear unit must not be used as an earthing point for electricwelding operations.
– All the fastening points provided by the design of the unit must be used.
– Screws which have been damaged during assembly or disassembly work must be replaced with new
screws of the same strength class and type.
Note
To ensure proper lubrication during operation, the mounting position specified on the drawings must
always be observed.
6.2
Unpacking
NOTICE
Material damage
Risk of damage to the gear unit through corrosion.
The packaging must not be opened or damaged beforehand, if this is part of the preservation method.
The products supplied are listed in the dispatch papers. Check immediately on receipt to ensure that all
the products listed have actually been delivered. Parts damaged and/or missing parts must be reported
to Siemens in writing immediately.
•
Remove packaging material and transporting equipment and dispose of in accordance with
regulations.
•
Perform a visual check for any damage and contamination.
WARNING
Serious injury through defective product
If there is any visible damage, the gear unit must not be put into operation.
The instructions in section 4, "Transport and storage", must be observed.
BA 5846 en 05/2015
46 / 109
Advertisement
Table of Contents
