Siemens FLENDER K SH Series Assembly And Operating Instructions Manual page 19

WARNING
Danger of squeezing
Risk of being squeezed by a transported component, when the used lifting gear and load­carrying means
are not suitable and the component gets loose.
The unit may be attached only at the marked slinging points. Use only lifting and load­carrying equipment
of sufficient load­bearing capacity.
When lifting items, observe the notes regarding load distribution on the packing.
The gear unit must be handled slowly and carefully, when lifted, to avoid personal injury and damage to
the gear unit.
If, for example, the free shaft ends are knocked, this may cause damage in the gear unit.
The gear unit is delivered in the fully assembled condition. Additional items may be delivered separately
packaged, if applicable.
Different forms of packaging may be used, depending on the size of the unit and method of transport.
Unless agreed otherwise, the packaging complies with the HPE Packaging Guidelines.
The symbols marked on the packing must be observed at all times. They have the following meanings:
Top Fragile
Fig. 3: Transport symbols
Note
The gear unit must be transported only with appropriate transport equipment.
During transport the gear unit should be left without oil filling and in the transport packing.
NOTICE
Material damage
Risk of damage to the gear unit when using incorrect attachment points. Use only the eyes provided to
attach lifting equipment to the unit.
Transport of the unit by attaching it to the pipework is not permitted.
The pipework must not be damaged.
Do not use the front threads at the shaft ends to attach slinging and lifting gear for transport.
Slinging and lifting gear must be adequate for the weight of the gear unit.
DANGER
Danger to life
Risk of being squeezed or killed by an axially not secured shrink disk.
If fitted with a shrink disk, the shrink disk must be secured axially before handling.
Keep dry Keep cool
BA 5846 en 05/2015
19 / 109
Centre of Use no hand
gravity hook
Attach
here