How To Set T.38 Redundancy Number Setting; How To Set Dialing Timeout Setting; How To Set Metering - Draytek Vigor VigorAccess IVD Quick Start Manual

How to Set T.38 Redundancy Number Setting

- Help
IVD/voip/misc> t38redundancy ?
- Display the setting
IVD/voip/misc> t38redundancy -s
- Edit the T.38 redundancy number
IVD/voip/misc> t38redundancy <Number>
Number

How to Set Dialing Timeout Setting

- Help
IVD/voip/misc> dialing_timeout ?
- Display the setting
IVD/voip/misc> dialing_timeout -s
- Edit the dialing completion timeout value
IVD/voip/misc> dialing_timeout <value>
Value

How to Set Metering

- Help
IVD/voip/misc> metering ?
- Display the setting
IVD/voip/misc> metering -s
- Setting Metering mode
IVD/voip/misc> metering -m <Metering Mode>
- Setting Reversal mode
IVD/voip/misc> metering -r <Reversal Mode>
-Setting Voltage
IVD/voip/misc>metering –v <Voltage>
Metering Mode
Reversal Mode
Quick Start Guide for VigorAccess
Assign a redundancy number in T.38 protocol. It means how many payloads
to be attached in the tail of packet.
0~4 (Default is 1)
1~60 (unit is second) (Default is 4)
0:Line polarity reversal (default)
1:12KHZ Tone
2:16KHZ Tone
0: Reverse as peer end-point On-hook (default)
1: Reverse as callee Off-hook
Version: 1.2
31