How to Login to DSL Module for Managing IVD Slave
Slave device have DSL/VoIP modules installed. The DSL module plays the core role for aggregating all
ATM traffic coming from DSL ports to the uplink Ethernet interface, and vice versa. Through the master
controller in the master device, administrator can login to the DSL module inside slave device for
managing IVD.
To DSL Module in IVD Slave Device
Only one slave device can be logged in at one time.
- IVD>dsl –c (Connect to dsl device via serial port)
- IVD>dsl –cf (Force the CLI access right to be occupied by a new operator)
How to Plug and Play Slave Device
By default, ports G1 to G6 on master device are disabled. If the slave connects to the master device,
please refer to the picture below to ensure the connection is working well.
Note: Ports G1 to G6 will be enabled with default if the DSL F/W version is above V2.10.2.6.
Please turn on the interface that connected to a
slave device. In the above picture, you have to
turn ON the interface G1, G4 and G6 for they
connect to different slave devices. Use the
command below to turn on the interface.
-
Admin>system link -m gn on
(n means "1" to "6")
-
Admin>system link
(check the status)
How to Check the Connectivity
To check the connectivity between the Master
and Slave Devices, please do the following:
1.
Login through terminal emulator software.
2.
Type the following command
-
Admin>dsl
Quick Start Guide for VigorAccess
The results
You will get the following results:
- Admin>dsl
Logic-Name
Slave-IP Connection-Status
dsl-slave-01 10.0.1.18 (NA)
dsl-slave-02 10.0.1.34 ON LINE
dsl-slave-03 10.0.1.50 ON LINE
dsl-slave-04 10.0.1.66 (NA)
dsl-slave-05 10.0.1.82 (NA)
dsl-slave-06 10.0.1.98 ON LINE
Version: 1.2
3