Table of Contents
Advertisement
How to Configure IP Address for Slave-Standalone Device
A slave device can work alone without connecting the master device. There are two types of slave device
that user might have. One is the device with two fast-ethernet interface version; the other is the device
with one gigabit-ethernet interface version.
For two fast-ethernet interface version, please set as the following
-
$aggr intf ifname aggr-0 ip <new-ip> mask <mask> usedhcp false
For one gigabit-ethernet interface version, please set as the following
-
$ethernet intf ifname eth-0 ip <new-ip> mask <mask> usedhcp false
Change back to master-slave architecture, please set as the following
-
$aggr (ethernet) intf ifname aggr-0 (eth-0) ip 0.0.0.0 mask 0.0.0.0 usedhcp true
How to Login with Telnet
For Master Device
1. Make sure the device IP has been configured
well.
2. Make sure the connection of MGN port (for
outband) or UPLINK port (for inband) is well
done.
3. Open Telnet command screen.
4. Username/Password
-
admin/1234
Now, please use Telnet commands to manage the master/slave device for your necessity.
How to Set G5 and G6 as UPLINK Interface
For the environment with available Fiber
connection, the UP-G connector in Master device
is used as the channel to access Internet. For such
condition, you can connect slave devices to G1 to
G6.
However,
available Fiber connection, G5 and/or G6 in
Master device can be used as the channel to
access Internet. For such condition, only G1 to
G4 connectors can be used for the slave devices.
For example,
-
Admin> system G6 up
or
-
Admin>system uplink G6 up
Enable the port by typing:
-
Admin>system link –m G6 on
Quick Start Guide for VigorAccess
(type 'exit' to return)
for the environment without
For Slave Device
1. Make sure the device IP has been configured well.
2. Make sure the connection of UPLINK port is well
done.
3. Open Telnet command screen.
4. Username/Password
-
(type 'exit' to return)
admin/1234
5
Advertisement
Table of Contents
