Function For Conversion Of Video Signals - Sony STR-DA5700ES Operating Instructions Manual

Function for conversion of video signals

This receiver is equipped with a function for converting video signals.
• Composite video signals can be output as HDMI video and component video signals.
• Component video signals can be output as HDMI video and video signals.
As the factory default setting, video signals input from the connected equipment are output to the
HDMI OUT or MONITOR OUT jacks as shown in the table below.
We recommend you set the video conversion function to match the resolution of the monitor you
are using.
For details on the video converting function, see "Video Settings" (page 109).
OUTPUT jack
INPUT jack
HDMI IN
VIDEO IN
COMPONENT VIDEO IN
a : Video signals are output.
– : Video signals are not output.
* Video signals may not be output, depending on the setting in "Resolution" (page 109).
Note on converting video
signals
Video signals for which the resolution has
been converted may not be output from the
COMPONENT VIDEO MONITOR OUT
jacks or the HDMI OUT jacks simultaneously.
If you connect equipment to both the
COMPONENT VIDEO MONITOR OUT
jacks and the HDMI OUT jacks, priority is
given to the output from the HDMI OUT jacks.
To display Closed Caption
Set "Resolution" to "Direct" in the Video
Settings menu when receiving a signal that
supports Closed Captions.
Use the same kind of cords for the input/output
signals.
22
US
COMPONENT
HDMI OUT A/B VIDEO MONITOR
(up to 1080p)
(up to 1080i)
a
a
a
MONITOR VIDEO
OUT OUT
– –
a* a*
a* a*
To connect a recording
equipment
When recording, connect the recording
equipment to the VIDEO OUT jacks of the
receiver. Connect cords for input and output
signals to the same type of jack, as VIDEO
OUT jacks do not have an up-conversion
function.
The HDMI OUT and the MONITOR OUT
jacks cannot be used for recording.
VIDEO 1 OUT
–
a
–