Function For Conversion Of Video Signals - Sony STR-ZA3000ES User Manual

Optimizer microphone (1)
Front cover (1)
[3] Preparation Before using
Notes on installing the receiver
Do not install the appliance in a confined space, such as a bookcase.
Sufficient space around the receiver is needed to release heat. When placing the receiver
in a rack, leave more than 44.45 mm (1.75 in) space above the receiver, and more than
44.45 mm (1.75 in) space along the sides of the receiver. The rack behind the receiver
should be open. If you place the receiver with its back against the wall, leave more than
88.9 mm (3.5 in) space between the receiver and the wall.
Make sure to use a "WS-RE1" dedicated rack mount kit for this receiver when mounting
the receiver on a rack mount.
Place the receiver in a location with adequate ventilation to prevent heat buildup and
prolong the life of the receiver.
Do not place the receiver near heat sources, or in a place subject to direct sunlight,
excessive dust, or mechanical shock.
Do not place anything on top of the cabinet that might block the ventilation holes and
cause malfunctions.
Magnets are attached to both the front panel and front cover. Do not place cards with
magnetic stripes, such as bank cards or ID passes, near the receiver. These cards may
become unusable due to the effects of the magnets on the receiver.
[4] Preparation Before using

Function for conversion of video signals

The receiver is equipped with a function for converting video signals. Video signals and
component video signals can be output as HDMI video signals (*1).
The correspondence of the INPUT jacks to the OUTPUT jacks is shown below.
HDMI IN: HDMI OUT
COMPONENT VIDEO IN: HDMI OUT (*1), COMPONENT VIDEO MONITOR OUT (*2)