Sony STR-DA5700ES Operating Instructions Manual page 50

Set "Speaker Impedance" to "8 Ω" in the
Speaker Settings menu.
– For other types of speakers in other
configurations:
Set "Speaker Impedance" to "4 Ω" in the
Speaker Settings menu.
To select the front speakers
You can select the front speakers you want to
drive.
SPEAKERS (A/B/A+B/OFF)
Press SPEAKERS (A/B/A+B/OFF)
repeatedly to select the front speaker
system you want to drive.
You can confirm which set of terminals (A or
B) are selected by checking the indicators in
the display window.
Indicators Selected speakers
The speakers connected to the
FRONT A terminals.
The speakers connected to the
FRONT B/FRONT HIGH
terminals.
The speakers connected to both the
FRONT A and FRONT B/FRONT
HIGH terminals (parallel
connection).
"SPEAKERS OFF" appears in the
display window.
No audio signals are output from any
speaker terminals, or the PRE OUT
jacks.
Note
If the speaker pattern is set so that there are front
high speakers, you cannot select the FRONT B/
FRONT HIGH terminals.
50
US
To use the receiver as a pre-
amplifier
You can use the "Auto Calibration" function
when you use the receiver as a pre-amplifier.
In this case, the distance value shown on the
display may differ from the actual distance
value. However, there will be no problems,
even if you continue to use the receiver with
that value.
To cancel the measurement
process
The measurement process is cancelled by the
following operations.
– Turning the power off
– Changing the volume
– Switching inputs
– Changing the setting of SPEAKERS (A/B/
A+B/OFF)
– Connecting headphones
Operations other than the above are not
allowed during the measurement process.
To set up the receiver manually
See "Adjusting Settings" (page 98).