Sony STR-DA5700ES Operating Instructions Manual page 139

you may not be able to record from the
sources.
• Set "Auto Standby" to "Off" (page 118).
While only composite video signals are
being recorded, the auto standby function
of the receiver may start up and interrupt
the recording.
Specific type of image is not output or
corrupted.
Component video output
• The resolution of output signals from the
COMPONENT VIDEO OUT jacks may
not be supported by your TV. In this case,
select the appropriate resolution on the
receiver (page 109).
• COMPONENT VIDEO MONITOR OUT
jacks have restrictions on resolution when
the resolution of video signals protected
by copyright technology is converted. The
resolution of the signals output to the
COMPONENT VIDEO MONITOR OUT
jacks is converted up to 480p/576p.
HDMI output
• The output of the HDMI video signals of
the receiver may be set to "OFF." In this
case, select "HDMI A" or "HDMI B"
using the HDMI OUTPUT button
(page 86).
• If the compatible video format differs
between the monitors connected to the
HDMI OUT A jack and the HDMI OUT B
jack of the receiver, "HDMI A + B" may
not work. In this case, select "HDMI A" or
"HDMI B" using the HDMI OUTPUT
button (page 86).
• Depending on the playback equipment
you connect, "HDMI A + B" may not
work. If the image is not output due to
settings on the playback equipment, set the
output setting on the playback equipment
to auto.
• Be sure to use a connecting cable for the
HDMI jack corresponding to High Speed
HDMI cable when you view images or
listen to sound, especially for the 1080p,
Deep Color, or 3D transmission.
• Set "Video Direct" to "On" in the HDMI
Settings menu in the following cases.
– Images from the equipment connected
to the HDMI jack may be distorted.
– Images or sound from the equipment
connected to the HDMI jack may be
interrupted when video signals are
switched.
– The start of the video is not output when
the 3D video is switched, or the colors
of the 3D video are improper.
3D image
• Depending on the TV or the video
equipment, 3D images may not be
displayed. Check the 3D image formats
supported by the receiver (page 150).
VCR
• If you use a VCR without an image
improvement circuit, such as TBC, the
images may be distorted.
Adobe or Adobe
RGB
• Set "Video Direct" to "On" to receive
Adobe or Adobe
RGB
When you select "My Video," "My
Music," "My Photo," "Internet Video,"
"Internet Music," "Internet Photo,"
"Internet Network," or "Sony
Entertainment Network" from the
Watch/Listen menu, no picture is
output.
• Select "BD/DVD" using INPUT
SELECTOR on the receiver once, then set
"Playback Resolution" to "480p/576p" in
the Video Settings menu using the GUI
(page 111), and select the content again.
The Pass Through function does not
work.
• "HDMI B" is selected. Select "HDMI A"
or "HDMI A + B" using the HDMI
OUTPUT button.
YCC601
signals.
YCC601
139 US