Mounting And Dismounting; Ibapadu-8; Mounting; Dismounting - IBA ibaPADU-8 Manual

6

Mounting and Dismounting

6.1

ibaPADU-8

6.1.1

Mounting

Locate the DIN-rail mounting clip on the rear side of the device. Place the device on the
DIN rail so that the top part the mounting clip engages the top part of the rail appropri-
ately. Slowly push down and in so that the bottom part of the mounting clips snaps onto
the bottom edge of the rail and firmly fixes the device to the DIN-rail.
Then connect power supply (correct polarity!), the analog and/or digital signal connec-
tions and the fiber optic cable(s). Shield if required.
6.1.2

Dismounting

Disconnect all external connections from the device.
Grasp the device with one hand firmly on the top side. With your free hand, grasp the
bottom of the device so that your index and middle fingers rest on the grounding screw.
Lightly push down with the hand on the top side of the device and simultaneously pull
forward with your other hand. With this action, the device should free itself from the
DIN-rail.
6.2

ibaPADU-32-R

6.2.1 Mounting
Fix the device with the four front panel screws into the cubicle. In case of high me-
chanical duty (acceleration > 1 g) support the device at the rear end or mount it on
rails.
Once fixed, on the rear side connect the power supply cord and switch on the device.
Connect fiber optic cable(s) to the TX/RX ports and set device mode and address with
the dial switches.
If the rear side of the device is not accessible after mounting, e. g. in case of closed
cubicle, back to the wall without a swing rack, take above mentioned actions vice ver-
sa. First connect the rear-side cables, dial mode and address and switch on the power
switch. Then move the device carefully into the cubicle (FO-cables, watch limited cable
bending!) and fix the four front panel screws.
6.2.2 Dismounting
Disconnect all external connections from the device. Unscrew the four front panel
screws (and the additional rear holding if present) while holding the device securely.
Remove device from cubicle.
If the rear side of the device is not accessible when inside the cubicle, act vice versa.
10
Manual
Issue 3.3
ibaPADU-8/ -16/ -32/ -32-R