Installing The Fork Protector; Removing The Fork Legs; Installing The Fork Legs - KTM SX-E 5 2021 Owner's Manual

13.6

Installing the fork protector

13.7

Removing the fork legs

13.8

Installing the fork legs

–
Position the fork protector on the left and right fork leg. Mount
and tighten screws
Guideline
Remaining screws,
chassis
–
Position the brake line and the clamp. Mount and tighten
2
screws .
Guideline
M01663-11
Screw, brake line
clamp on fork protec-
tor
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
Main work
–
Remove screws
–
Remove screws
–
Allow the brake caliper and the brake line to hang loosely to
the side.
Info
Do not kink the brake line.
M01664-10
–
Note the installation position of the fork legs.
–
Loosen screws
–
Loosen screws
M01812-10
Condition
Individual installation position
–
Position the fork legs.
Guideline
Observe the position determined during removal.
Bleeder screws
Condition
Standard installation position
F02179-10
–
Position the fork legs.
SERVICE WORK ON THE CHASSIS 13
1
.
M6 10 Nm (7.4 lbf ft)
EJOT PT ® 2 Nm (1.5 lbf ft)
K60x20‑AL
( p. 76)
1
and take off the clamp.
2
and take off the brake caliper.
3
. Remove the left fork leg.
4
. Remove the right fork leg.
1
are positioned toward the rear.
p. 45)
47