Removing The Lower Triple Clamp - KTM SX-E 5 2021 Owner's Manual

13 SERVICE WORK ON THE CHASSIS
13.9
48
M01812-11
M01665-10

Removing the lower triple clamp

M01667-10
1
Bleeder screws
The second milled groove (from the top) is flush with
the upper edge of the upper triple clamp.
–
2
Tighten screws .
Guideline
Screw, top triple
clamp
–
3
Tighten screws .
Guideline
Screw, bottom triple
clamp
–
Position the brake caliper, mount screw
Guideline
Screw, front M8x60
brake caliper
–
Mount and tighten screw
Guideline
Screw, front M8x40
brake caliper
–
Position the brake line and the clamp. Mount and tighten
6
screws .
Guideline
Screw, brake line
clamp on fork protec-
tor
Finishing work
–
Install the front wheel.
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs. (
–
Remove the start number plate. (
–
Remove front fender. (
Main work
–
1
Remove nut .
–
Remove the cable tie on the magnetic switch cable from the
handlebar.
–
2
Release screw , take off the upper triple clamp with the
handlebar and set aside.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
are positioned toward the rear.
M8 20 Nm (14.8 lbf ft)
M8 15 Nm (11.1 lbf ft)
4
, and tighten.
20 Nm (14.8 lbf ft)
Loctite
5
.
20 Nm (14.8 lbf ft)
Loctite
EJOT PT ® 2 Nm (1.5 lbf ft)
K60x20‑AL
( p. 76)
p. 45)
( p. 76)
p. 47)
p. 52)
p. 53)
® 243™
® 243™