System Messages - KBL beautyShaper Operating Instructions Manual

11. System messages

After the error has been eliminated, all error messages must be acknowledged by pressing START on the interior control panel.
No. Status message
Excess temperature
01
bimetal
02 Maximum tanning time!
Excess temperature
03
exhaust fan!
KBL7 Hardware error
12
Input-Controller
Maximum write cycle
13
flash memory reached
Error! SD card read error
14
(CRC fault)
Error! no access to the
15
SD card
Parameter storage not
17 found, please connect
and restart
Parameter storage no
18
valid serial number
CAN-BUS: Interior dis-
19
play V1 is incompatible
CAN-BUS: preSelec-
20 tion display V1 is
incompatible
CAN-BUS: audio module
21
full V1 is incompatible
CAN-BUS: RGB module
22
V1 ist incompatible
Parameter storage write
23
error
Parameter storage read
24
error
Frequency detection:
25
detection failed!
Frequency detection:
power supply connection
26
faulty (connector X6/E6)!
Excess Temperature
28
Excess Temperature
29
38
O p e r a t i n g I n s t r u c t i o n s | KBL Tower beautyShaper
ERROR MESSAGES
Description
Bimetal switch triggers.
Enabling signal from coin-box system
comes in longer than the time value
approved under "Maximum tanning
time" (voltage remains connected)
Bimetal switch in the fan triggers.
Mainboard defective.
Maximum write cycle flash memory
reached.
Update via SD card failed (CRC fault).
Update via SD card failed (access
error).
Parameter storage not found, please
connect and restart.
Parameter storage no valid serial
number.
CAN-BUS operators incompatible.
Parameter storage write error.
Parameter storage read error.
Frequency detection failed.
Frequency detection failed. No mains
voltage.
Device is running at temperature limit
Device exceeds the temperature limit
Remedy
Check the air-intake/air-exhaust system. Let the
device cool down.
Disconnect from the coin-box system.
Make sure the fan runs freely. Check the air-
intake/air-exhaust system. Let the device cool
down.
Contact your Customer Service.
Contact your Customer Service.
SD card check / replace.
SD card check / replace
Check connector parameter storage. If neces-
sary replace parameter storage.
Contact your Customer Service.
Use CAN-BUS operaters V2.
Check connector parameter storage. If neces-
sary replace parameter storage.
Check connector parameter storage. If neces-
sary replace parameter storage.
Restart the controller. Contact your Customer
Service after the third unsuccessful restart.
Check mainboard connector X6/E6.
Let the device cool down. If the error repeats,
contact your customer service.
Let the device cool down. If the error repeats,
contact your customer service.