Husqvarna K970 SmartGuard Workshop Manual page 68

5. Push out the spindle to the right side. Use a rod with
a diameter of 0.08–1.0 in./2–2.5 mm and minimum 4
in./10 mm in length and remove the throttle trigger.
6. Push out the spindle to the right side. Use a rod with
a diameter of 0.08–1.0 in./2–2.5 mm and
approximately 4 in./10 mm in length and remove the
throttle control wheel.
7. Remove the wire from the throttle control wheel.
6.16.2 To examine the throttle trigger lockout
The throttle trigger lockout operates correctly if the
throttle trigger is locked at idle speed.
• Make sure the throttle trigger cannot be released
until the throttle trigger lockout is pressed.
68 - Repair and servicing
6.16.3 To install the throttle trigger and throttle
trigger lockout
The spindles for the throttle trigger and the throttle
control wheel must be installed from the right side.
1. Install the throttle trigger from the carburetor area
(A). Make sure that the spring comes out through
the handle (B).
2. Install the wire into the throttle control wheel.
3. Install the throttle control wheel (A). Attach it with a
pin (B).
B
B
A
A
1451 - 001 - 02.04.2020