Husqvarna K970 SmartGuard Workshop Manual page 29

6.2.8 To remove the stop switch
1. Remove the screw and the cable.
2. Pull out the the switch approximately 10 mm (A).
C
A
3. Push the clip with a screwdriver (B).
4. Remove the switch (C).
1451 - 001 - 02.04.2020
6.2.9 To install the stop switch
1. Push the switch into position (A).
2. Push the side until it locks (B).
3. Push the side until it locks (C).
4. Tighten the screw. Connect the cable to the stop
switch.
B
A
B
Repair and servicing - 29
C